Installation Guide

For Sleeper Size: 1500mmL x 150mmH

Before you start you will need:

• Work Gloves
• Tape Measure
• Quick Set Concrete
• ShovelStar Pickets
• Real-Lite Concrete Sleepers
• Level & String Line
• Post Hold Digger
• Real-Lits Gal Steel Posts
• Planning Sheet
• Weed Mat
• Ag Pipe

• Design and measure your retaining wall length, and using our Planning Sheet calculate the number of posts and sleepers required.

• Prepare the site, clear and level the area leavins 200mm behind the wall for backfilling
• Hammer in Star Pickets at begining and end of the proposed wall setting the star pickets 500mm past each end
• Run a stringline at the top of the propoed wall height and along the bottom, ENSURE IT IS LEVEL
• Mark out location of holes (hold centres 1520mm)

• Dig holes where marked with a minimum 300mm diameter hole
• Hole depth must be the same height of the proposed wall plus 50mm for concrete coverage on bottom of post

• Fill the hole with concrete and place the post in the centre using a level to ensure the post is straight and lines up with top of the string line
• Repeat for remaining holes

• It is reccomended that concrete cures for 24 hours or use rapid set concrete
• Slide Sleepers into place between posts

• Place weed mat against back of wall
• Using 65mm Ag Piper at the back base of the wall, backfill with 20mm gravel to 200mm from top of the wall
• Fill to top of the wall with clay soil

How to install